Polaris SCRAMBER 500 Manuel d'utilisateur télécharger pdf (Page 105)

102

MAINTENANCE

Battery

Battery Charging (Sealed Battery)

The following battery charging instructions apply only t o the

installation of a sealed battery. Read all instructions before proceeding

with the installation of this battery.

The sealed battery is already filled with electrolyte and has been sealed

and fully charged at the factory. Never pry the sealing strip off or add

anyotherfluidtothisbattery.

The single most important thing about maintaining a sealed battery is

to keep it fully charged. Since the battery is sealed and the sealing strip

cannot be removed, you must use a voltmeter or multimeter to measure

DC voltage.

WARNING

An overheated battery could explode, causing severe injury or

death. Always watch charging times carefully. Stop charging if the

battery becomes very warm to the touch. Allow it to cool before

resuming charging.

For a refresh charge, follow all instructions carefully.

1. Check the battery voltage with a voltmeter or multimeter. A fully

charged battery will register 12.8 V or higher.

2. If the voltage is less than 12.8 volts, recharge the battery.

NOTE: When using an automatic charger, refer to the charger

manufacturer’s instructions for recharging. When using a

constant current charger, use the following guidelines for

recharging.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 128 129

Pas de commentaire

Polaris SCRAMBER 500 Manuel d'utilisateur Page 105