Polaris SCRAMBER 500 Manuel d'utilisateur télécharger pdf (Page 111)

108

MAINTENANCE

Cleaning and Storage

Storage Tips

Fluid Levels

Inspect the fluid levels. Add or change fluids as recommended in the

Periodic Maintenance Chart beginning on page 62.

S Demand drive unit (front gearcase)

S Rear gearcase (if equipped)

S Transmission

S Brake fluid (change every two years and any time the fluid looks

dark or contaminated)

S Coolant (test strength/fill)

Fog the Engine

1. Support the front end of the ma ch ine so the engine is le vel or tilted

slightly rea rw ar d.

2. Remove the spa rk plug.

3. Pour 2-3 tablespoons (29-44 ml) of Premium 4 Synthetic 0W40

engine oil into the hole.

NOTE: Use a section of small hose and a small plastic squeeze bottle

filled with the pre-measured amount of oil.

4. Reinstall the spark plug. Torque to specification.

5. Apply dielectric grease to the inside of the spark plug cap.

Reinstall the cap.

6. Turn the engine over several times using the recoil starter. Oil will

be forced in and around the piston rings and ring lands, coating the

cylinder with a protective film of fresh oil.

7. Treat the fuel system with P olaris Carbon Clean. See page 107.

8. If Polaris fuel system additive is not used, the fuel tank, fuel lines,

and carburetor should be completely drained of gasoline.

9. To eliminate any fuel remaining in the carburetor, run the engine

until it stops.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 128 129

Pas de commentaire

Polaris SCRAMBER 500 Manuel d'utilisateur Page 111