Polaris PHOENIX 200 Manuel d'utilisateur télécharger pdf (Page 42)

FEATURES AND CONTRO LS

Kick-Start Lever

If the battery becomes too weak to start the engine, use the kick-start

lever to start the engine until the battery is serviced.

1. Position the vehicle on a level surface.

2. Lock the parking brake.

3. Place the t ransmission in neutral.

1. Fold out the kick-start lever on the l eft side of the ATV.

2. Make sure the stop switch and main key switch are on.

3. Place your foot on the kick-start. Thrust your heel downward to

crank the engine.

NOTE: If the engine is cold, use the choke as outlined on page 44.

4. After the engine has started, fold the kick-start lever back into

place.

NOTE: A 10/12 mm wrench is provided in the tool kit for removing or

installing the lever . If not installed, make sure the rubber cap

is installed on the kick-start shaft to protect the rider. Store

the kick-start lever under the seat in the rear cab when not

installed.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 110 111

Pas de commentaire

Polaris PHOENIX 200 Manuel d'utilisateur Page 42