Polaris 2013 WideTrak LX Manuel d'utilisateur télécharger pdf (Page 95)

MAINTENANCE

Track

Track Alignment

Periodically check that the track is centered and running evenly on the

slide rails. Misalignment will cause excessive wear to the track and slide

rail.

1. Safely support the rear of the snowmobile with the track off the

ground.

2. Start the engine and apply a small amount of throttle until the track

turns slowly at least five complete revolutions. Stop the engine and

let the track come to a stop (do not apply brakes).

3. Inspect track alignment by

looking through the track

window to make sure the

rails are evenly spaced on

each side. If the track runs to

the left, loosen the left lock-

nut and tighten the left

adjusting bolt. If the track

runs to the right, loosen the

right locknut and tighten the

right adjusting bolt.

4. After adjustments are com-

plete, tighten locknuts and

torque idler shaft bolts to 35 ft. lbs. (47.5 Nm).

5. Repeat steps 2 and 3 to verify proper alignment.

Rails

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 130 131

Pas de commentaire

Polaris 2013 WideTrak LX Manuel d'utilisateur Page 95