Polaris 2003 MSX Manuel d'utilisateur télécharger pdf (Page 45)

OPERATION

Pre-Operation Inspection

Jet Pump Intake

1. Ride Plate 2. Impeller

3. Drive Shaft 4. Intake Grate

1. Remove the lanyard lock plate from the stop

switch and disconnect the battery cables before

inspecting the jet pump intake. Disconnect the

negative (black) cable first.

2. Carefully check the jet pump intake and remove

any weeds, shells or other debris that may restrict

the intake of water.

3. After launching, walk the watercraft into water at

least two feet (60 cm) deep and bounce the back of

the craft up and down several times to flush out

any sand and debris that may be in the pump.

WARNING

Improperly connecting or disconnecting battery

cables can result in an explosion and cause

serious injury or death. When disconnecting

cables, always disconnect the negative (black)

cable first. When reconnecting, always connect

the negative (black) cable last.

CAUTION

A clogged intake or the ingestion of sand into the

cooling system will cause engine overheating and

result in jet pump or engine damage. If any

obstruction cannot be removed, have an

authorized Polaris dealer service it immediately.

Clear the pump of sand after operating in shallow

water or after beaching the watercraft.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 113 114

Pas de commentaire

Polaris 2003 MSX Manuel d'utilisateur Page 45