Polaris 2003 MSX Manuel d'utilisateur télécharger pdf (Page 65)

OPERATION

Beaching the Watercraft

1. Slowly approach the beaching area and stop the

engine in no less than two feet (60 cm) of water.

Make sure there are no swimmers, boats or other

obstacles close to the watercraft, as it will be

impossible to turn the watercraft after stopping the

engine.

2. Dismount the watercraft and guide it to the beach.

3. Before restarting, inspect the impeller/jet pump

area for sand and debris.

4. Move the watercraft to at least two feet (60 cm) of

water and push the rear of the watercraft up and

down in the water to help flush sand and debris out

of the pump.

CAUTION

Sand, pebbles, weeds and debris can enter the jet

pump and cause severe damage to components.

Ingestion of sand into the cooling system may

cause the engine to overheat and could result in

severe engine damage. Never beach the watercraft

while the engine is running. Shut off the engine

when entering water less than two feet (60 cm)

deep.

Step 2

Step 4

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 113 114

Pas de commentaire

Polaris 2003 MSX Manuel d'utilisateur Page 65