Polaris 2003 MSX Manuel d'utilisateur télécharger pdf (Page 95)

MAINTENANCE AND LUBRICATION

Extended Storage

Watercraft Engine Fogging Procedure

Polaris recommends the use of fogging oil to prevent

rust and corrosion on internal engine parts (i.e.

crankshaft, bearings, pistons, rings, cylinder walls).

The fogging oil coats all internal parts for prevention

of rust and corrosion, which in turn will extend the life

of the engine. See page 101 for part numbers of Polaris

products.

1. Remove the

three caps (1)

in the top of

the air intake

cover.

2. Start the engine and

spray Polaris fogging

oil into the hole in the

intake cover (2) to

ensure that all internal

parts are properly

coated. Spray the oil

for two to three

seconds in each hole and repeat to flood the engine

with fogging oil. Immediately stop the engine.

3. Replace the caps in the air intake cover.

CAUTION

Failure to fog the engine can result in serious

engine corrosion during off season or extended

storage. Always fog the engine as outlined before

storing the watercraft for extended periods.

CAUTION

Operating the engine while the watercraft is out of

the water will cause the engine to overheat and

seize. Never operate the engine for more than 15

seconds while the watercraft is out of the water.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 113 114

Pas de commentaire

Polaris 2003 MSX Manuel d'utilisateur Page 95