Polaris 2012 WideTrak LX INTL Manuel d'utilisateur télécharger pdf (Page 86)

MAINTENANCE

Clutch System

Drive Belt Removal

1. Stop the engine after operating in a forward motion.

NOTICE: Do not attempt to remove the drive belt after operating in reverse. The

snowmobile must be stopped after forward motion to prevent damage

to components during belt removal.

2. Turn the ignition key off. Wait for the engine to stop completely.

3. Lock the parking brake (if equipped).

4. Open the hood.

5. Remove the clutch guard retaining pin and open the clutch guard.

6. Rotate the driven clutch counterclockwise 1/4 turn by hand to

ensure forward engagement before attempting to remove the belt.

7. Locate the L-wrench in the tool kit. Install the wrench into the open

threaded hole in the outer sheave of the clutch.

8. Turn the wrench clockwise until the sheaves open far enough to

remove the belt. If the wrench does not turn readily, rotate the

driven clutch counterclockwise an additional 1/4 turn by hand and

try again.

9. Grasp the belt at the lower edge and remove it.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 127 128

Pas de commentaire

Polaris 2012 WideTrak LX INTL Manuel d'utilisateur Page 86